x

Disclaimer – please make sure to verify the exact phone number, address, contact information, and emails, before shipping out any products to GNBS, as our company has been the subject of several fraudulent scams over the past few months. We will not be responsible for any orders shipped to any others locations that have not been verified beforehand. Thank you.

Frequently Asked Battery Questions

Frequently Asked Battery Questions

Battery replacement may be necessary if you experience any of the following: loss of power in cold or extended starts, slow or interrupted turnover of the starting motor, or battery discharge light on the vehicle instrument panel is lit. If you are experiencing any of these symptoms, you should have your battery and/or electrical system checked.

Heat and vibration are the most harmful elements to an automobile battery. However, many other factors can cause battery failure, such as: corroded cables and terminals, lack of electrolyte maintenance, sulfating, alternator/regulator malfunction, and electric shorts.

If a battery was discharged quickly then it should be recharged quickly, and a slowly discharged battery should be recharged slowly. The main concern is to not overheat nor overcharge the battery.

All batteries contain sulfuric acid and can generate explosive gases. Read and follow all warning labels before charging a battery. Be sure to charge in a well-ventilated area.

It is important to follow the charging instructions to ensure that the battery is returned to a full charge as battery chargers vary by manufacturer. For best results, charge the battery as soon as you know it is discharged.

For charging an average fully discharged automotive battery using a 10-amp automotive charger, it will take approximately 8-10 hours at 80 degrees F temperature to reach full charge.

Warning: Once a battery has been fully charged, it should be disconnected from the charger immediately. Continuing to charge a fully charged battery will severely damage the internal plates and shorten battery life.

Many automobile batteries come with 2 removable vent caps at the top of the battery. These caps can be removed to check the electrolyte level in the battery. If the level appears low, add distilled or good quality drinking water to the fill wells. DO NOT OVERFILL! Overfilling can cause acid to be discharged from the battery during operation. The fluid level should be checked at least once a year in cold or mild climates and more often in hot climates.

While checking the electrolyte, you should also check the battery terminals for signs of corrosion. Clean the terminals and attached cables of any dirt and corrosion to ensure a good connection and proper starting. By removing any oil and dirt from the battery's casing, you will reduce the risk of short circuiting.

Heat increases the rate of evaporation, which causes a loss of water from the electrolyte. Extreme heat also increases the rate of self-discharge and promotes the corrosion of the positive plate grids. Extreme cold dramatically reduces the speed at which chemical reaction can occur, while increasing electrolyte resistance.

It is important to keep batteries at a full charge during periods of extreme cold. Batteries in a discharged state are susceptible to freezing, which can cause damage to the plates and battery container. Automobiles demand more from a battery in freezing temperatures as the motor oil thickens and makes the engine harder to crank.

Heat is the number one killer of a battery; although it increases the performance of the battery short-term, life is drastically reduced over time.

Cranking amps are the numbers of amperes a lead-acid battery at 32 degrees F (0 degrees C) can deliver for 30 seconds and maintain at least 1.2 volts per cell (7.2 volts for a 12 volt battery).

In other words, CA/cranking amps determine how much power you have to start your car in most climates. The basic job of a battery is to start an engine; it must crank, or rotate the crankshaft while at the same time maintain sufficient voltage to activate the ignition system until the engine fires and maintains rotation. This requirement involves a high discharge rate in amperes for a short period of time.

Since it is more difficult for a battery to deliver power when it is cold, and since the engine requires more power to turn over when it is cold, the Cold Cranking rating is defined as: The number of amperes a lead-acid battery at 0 degrees F (-17.8 degrees C) can deliver for 30 seconds and maintain at least 1.2 volts per cell (7.2 volts for a 12-volt battery).

In other words, CCA/cold cranking amps determine how much power you have to start your car on cold winter mornings.

Reserve capacity is the time in minutes that a new, fully charged battery will deliver 25 amperes at 80 degrees F and maintain a terminal voltage equal to, or greater than, 1.75 volts per cell. This rating represents the time the battery will continue to operate essential accessories if the alternator or generator of a vehicle fails.

Put another way, reserve capacity is a battery's ability to sustain a minimum vehicle electrical load in the event of a charging system failure. Under the worst conditions (winter driving at night), this minimum could require current for ignition, low beam head lamps, windshield wipers, and defroster while driving at low speeds.

Batteries come in many different group sizes. A battery's group size simply determines it's length, width, height, and terminal configuration; this has nothing to do with a battery's capacity. Regardless of the group size, two batteries are equal in power if the CCA ratings are the same.

New technology enables a great deal of power to be put into smaller cases with today's new high capacity output design.

Most automobile batteries are maintenance accessible. Remove the vent caps which will expose 6 holes or fill wells, add distilled or good drinking-quality water. BE CAREFUL NOT TO OVERFILL. The electrolyte should not go past the end of the fill well. Overfilling can cause acid to be discharged during operation. The electrolyte level should be checked at least once a year in cold or mild climates and more often in hot climates.

Other additives:

Under normal conditions, a battery fails due to the deterioration of the positive grids and active material. Additives will not restore the integrity of the metal grid nor replenish the active material onto the plate. Simply stated...DO NOT add additives!

When storing an automobile battery, it is important to make sure it is at a full charge and the electrolyte level is full. A battery stored in a discharged state is susceptible to freezing sulfation and an increased rate of further discharge. The battery should be placed in a cool dry area, the cooler the better without going below 32°F, that is well ventilated and out of reach of children and pets.

A battery will not lose its state-of-charge strictly from placing it on a concrete surface, but will discharge it over a period of time, due simply to neglect.

Conscientious battery distributors and manufacturers play an important role in the success of recycling programs. Great Northern Battery Systems accepts spent batteries and channel them into the recycling process. Automotive lead acid batteries are up to 99% recyclable.

Nothing... a marine starting battery is essentially the same as an automotive battery with a handle and marine terminals added.

Marine/RV Deep Cycle Batteries have thicker plates, a lower cranking ability, however they have a lot more reserve capacity. Deep Cycle Batteries endure a lot more discharge/recharge cycles than starting batteries.

Over 79 Years of Wholesale Battery Experience Working for You! Call us Toll Free at 1-877-549-4454